Description
S-5! RibBracket IV Mounting Bracket for Metal Roofs
RibBracket IV
Designed for popular North American and Indian profiles, such as PBR Panel, R-Panel, Kirby Roof (KR), and similarly-dimensioned profiles.
Compatible RibBracket IV top rib dimension range:
1 ¼ in +/- to 1 ⅜ in (32 mm to 35 mm)
Product Specifications
- Flex-to-fit legs ensure proper fit
- Large channel above rib can be used for wire management
- Sheeting-only attachment can be placed anywhere along roof ribs
- Stainless-capped, self-piercing screws specifically designed to maximize holding strength & prevent swarf
- EPDM sealing washer
- Bracket allows for 4” (100 mm) of air space above rib
- 4 self-piercing screws and 1 M8 nut included
Flexible Legs Accommodate Various Trapezoidal Metal Roof Profiles
The RibBracket I-V is used with the PVKIT MidGrab and EdgeGrab for (rail-less) solar PV mounting. This metal roof bracket comes in five different sizes and is an economical, sheeting-only attachment solution that can be placed anywhere along the roof ribs. RibBracket I-V is not limited to the location of the building substructure, offering infinite flexibility for module placement anywhere on your roof. You can mount microinverters and other module-level power electronics as well.
Angled Attachment to Resist Pull-Out
The RibBracket I-V design converts upward pull from wind uplift into shear, achieving unsurpassed holding strength. The slotted top hole provides lateral adjustability of the PVKIT for space correction and to easily square up the modules. RibBracket I-V provides 4” (100 mm) of air space, allowing ample airflow for module cooling and easy access for installation. The part has a channel for wire management.
Which RibBracket I-V is Right for Your Roof Profile?
Trapezoidal profiles vary in angles and dimensions. Most one-size-fits-all solutions offered by others involve top-down fastening, which puts the fastener in direct withdrawal (or pull-out). These pull-out values in sheet metal are extremely low, putting the PV array at risk of blow-off.
The design of the RibBracket I-V places fasteners in shear rather than pull-out. This provides a substantially stronger attachment. These metal roof brackets are therefore specifically designed to accommodate a variety of trapezoidal rib angles and dimensions.
Do not use RibBracket I-V with rails.
S-5! also offers a fully adjustable option that fits all trapezoidal profiles with the same technologies as discussed above, but at a higher cost. Visit the ProteaBracket to learn more.
What's Included
- (1) RibBracket IV
- (4) Self-piercing screws
- (1) M8 nut
Attachments
