Description
Cotek SD1500-148 HARDWIRE, UL Pure Sine Wave Inverter with AC Transfer Switch 48VDC 120VAC 1500W
Features
- Parallel redundancy design for power expansion
- 1Ф3W / 3Ф4W for multiple industrial applications
- Built-in ATS and AC circuit breaker
- Selectable output voltage and output frequency
- RS-232 communication interface
- Hardwire AC output, UL approved
- Input & output fully isolation
- Output voltage / power saving mode selectable by DIP switch or remote control (via CR-10)
- Input protection: Reverse Polarity (Fuse) / Under Voltage / Over Voltage
- Output protection: Short Circuit / Overload / Over Temperature / Over Voltage
- Pressed steel housing
- UL / CE approved
Accessory:
- Remote controller CR-6
- Remote controller CR-8
- Remote controller CR-10
FAQs
- Can I stack Cotek SD Series inverters to create a split-phase system?
Yes, Cotek SD Series inverters can be stacked to double your wattage in a 120/240 split phase output. See image below taken from the User Manual.
- The datasheet shows output wattage, but what is continuous wattage?
The output power listed on the spec sheet is the continuous power output under perfect conditions (Power factor = 1). However, this will be affected by the power factor of your load. For example, LED lighting can have a power factor of around 0.9 so you take 1500VA x .9PF = 1350 watts. For this reason, you may want to consider sizing your inverter 15-20% higher than your peak load. This compensates for the variance in PF across various loads.
Attachments
